(1) When using the minimum bending radius, use the elbow as shown in the figure, and do not bend the hose sharply.
(2) In order to prevent curling, we must ensure that the placement position of the hose is consistent with the bending direction of the hose.
(3) When the internal pressure of the hose is applied, the length of the hose will cause some changes. But remind everyone not to fix the bent part of the hose in order to suppress such changes.
(4) When using high voltage, since the length change range is between 2% and -4%, during the installation process, it is necessary to leave enough room for expansion and contraction of the hose.
(5) To reduce the number of joints, please use suitable accessories instead of pipes for good appearance and shortening the assembly.
(6) When using elbows for hydraulic hose connections, be careful not to severely twist or bend the hose.
(7) Using auxiliary accessories, arrange the hoses in a straight line. This can prevent the hose from being too long and make the appearance simple and beautiful. After many old drivers install the hose, they are neat and tidy. The reason is this detail.
(8) The length of the hydraulic hose must have an appropriate margin. This allows for smooth movement of the hose and avoids sharp bends.
(9) When the hydraulic hose is bent and installed on different sides, in order to prevent twisting, the hose can be fixed in one plane as shown in the figure.
(10) In order to prevent the hydraulic hose from being twisted during installation, the marking on the hose can be used as a twist prevention line. In addition, when the connector has a connecting nut, you must use a wrench to apply force to the hexagon of the screw to be installed.
